»   » Bosch Speed tuning chip set

Bosch Speed tuning chip set

Price: £150 (REF: 1189)

{Description}Bosch Speed tuning chip set for Bosch Performance is a revolutionary processor-controlled module which increases the maximum speed of your electric bike to 50km/h. Unlike any other tuning kit on the market for your E-Bikes, this shows the correct speed, mileage and range using the chip set where as other would still show the limited speed of 25km/h
Once you have finished using the Bike you treat it like you normally would, simply turn it off and use it when needed. However when you turn your e-bike back on, half the mileage is deducted from the total mileage (only for the period of time for which Bosch Speed tuning was activated during the previous ride). In practice, it means that your bike has lower mileage than what you actually have done.
{Specification}Bosch Speed tuning is activated with a short push of the LIGHT button situated in the front part of the control panel.
After this button has been pushed, the actual speed of 5.0 km/h is displayed on the control panel for approximately 2 seconds.This signifies that Bosch Speed tuning is activated and the assistance of your e-bike now functions up to the speed of 50 km/h.
If you push the above mentioned button, the actual speed of 2.5 km/h is displayed. This signifies that Bosch Speed tuning is deactivated and everything functions as it there was no tuning chip set. Thanks to this function, your e-bike is back to its original speed setting.
It is possible to activate Bosch Speed tuning out of public roads, preferably on your own land. Please, be careful as the difference between 25km/h and 50km/h can be quite a shock. The manufacturer assumes no liability for damages resulting from the use of this device. It is illegal to use the speed function on the public roads as this could cause incidents, this chip set is intended for use for sporting events.
Installation of Speed Speed Chip Tuning Set for Bosch:1, Disconnect the battery from the electric bike.2, Loosen the screw of the left handle and remove the handle.3, Loosen 3 torx screws holding the plastic engine cover and lift off the cover.4, Disconnect the connector of speed sensor and display connector.5, Connect the Speed Chip Tuning Set to disconnected sensors.6, Connect contacts of Speed Chip Tuning Set to original connectors.7, Close the plastic engine cover and screw 3 torx screws holding this cover.8, Install the left handle and tighten the centre screw of the handle.9, Connect the battery of electric bike. Operation of Speed Chip Tuning Set for Bosch:1, Turn on the electric bike.2, Activation and deactivation is done by WALK button placed on the handlebars.3, After turning off the electric bike the Speed Chip Tuning Set is always off.4, After the first pushing of WALK button the display shows for one second the current speed of 50km/h. The Speed Chip Tuning Set is active and your bike will ride at the speed up to 50km/h.5, After next pressing the WALK button the display shows the speed of 2.5km/h it means that the SpeedBox2 is disabled and the supplementary assistance of the electric bike is active only up to speed of 25 km/h.Notice: Regulations Installation of Speed Chip Tuning Set for Bosch:1, Disconnect the battery from the electric bike.2, Loosen the screw of the left handle and remove the handle.3, Loosen 3 torx screws holding the plastic engine cover and lift off the cover.4, Disconnect the connector of speed sensor and display connector.5, Connect the Speed Chip Tuning Set to disconnected sensors.6, Connect contacts of Speed Chip Tuning Set to original connectors.7, Close the plastic engine cover and screw 3 torx screws holding this cover.8, Install the left handle and tighten the centre screw of the handle.9, Connect the battery of electric bike.Operation of Speed Speed Chip Tuning Set for Bosch:1, Turn on the electric bike.2, Activation and deactivation is done by WALK button placed on the handlebars.3, After turning off the electric bike the Speed Chip Tuning Set is always off.4, After the first pushing of WALK button the display shows for one second the current speed of 50km/h. The Speed Chip Tuning Set is active and your bike will ride at the speed up to 50km/h.5, After next pressing the WALK button the display shows the speed of 2.5km/h it means that the Speed Chip Tuning Set is disabled and the supplementary assistance of the electric bike is active only up to speed of 25 km/h. Notice: Regulations 1, Make sure that the use of products Speed Chip Tuning Set isnīt in conflict with current legislation of the country in which you will use your electric bike.2, Be considerate of your surroundings when driving.3, The producer assumes no responsibility for damages caused by using products SpeedBox and Speed Chip Tuning Set.4, Always use bike helmet and other protective gears.

Next Previous Testimonials